This vinyl product comes in 3 variations; heat transfer vinyl (HTV), heat transfer vinyl with glitter, or adhesive (permanent) vinyl. See details for each below.
Fairy Tale Adhesive Vinyl Features:
- Thickness: 4 mil
- Adhesive: Grey, solvent-based, permanent adhesive
- Release Liner: PE-coated silicone paper
- Durability: 5 years
- Application Min Temp: 46°F
- Usage: For general signage and other mid-term indoor and outdoor applications.
- Proudly Made In USA
Application Instructions
- When installing your graphic, always apply the material using a dry application method; under no circumstances should a wet application be used. Also be careful when using a heat source during installation as this can cause the material to warp and not register during panel installations.
- Lay the graphic, image-side down, on a flat surface and pull back the liner about 6-12 inches.
- Sharply crease the liner while holding it away from the adhesive.
- Align the graphic on the wall and use finger pressure to tack in place.
- Using a Squeegee, work from the center to the edge, then return to the center and work to the opposite edge.
- Use overlapping strokes while applying a small portion of the graphic at a time. If your graphic is made up of more than one panel, avoid using horizontal seams when possible.
- When the entire graphic has been applied to the wall, reapply pressure with the Squeegee around the edges of the graphic multiple times to ensure a good bond.
- Post heating the graphic edges is recommended between 100 °F - 150°F If the graphic will come into contact with regular cleanings, such as mopping, soil removal, etc., graphics should be sealed in those areas. This is especially important where the graphic is terminated at the floor. Use of a clear silicone sealant along the edges of the graphic is recommended.
Recommended Accessories:
Application Tape
Squeegee
Fairy Tale HTV is:
- Layerable
- Iron-On friendly
- CPSIA Certified
- Proudly Made In USA
Fairy Tale HTV Applies To:
- 100% Cotton
- 100% Polyester
- Poly/Cotton Blends
Application Instructions For Fairy Tale HTV
Home Iron Instructions • Cut design in positive (Do not mirror) • Mask with TTD Mask • Set iron dial between Cotton and Linen • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 15 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier cold
|
Heat Press Instructions • Cut design in positive (Do not mirror) • Mask with TTD Mask • Set iron dial between Cotton and Linen • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Preheat garment for 2-3 seconds • Apply design at 305°F/150°C • Use medium pressure for 10-15 seconds • Peel carrier cold
|
|
Click here for Fairy Tale HTV application instructions
Watch How To Video HERE!
Laundering Instructions
- Wait 24 hours before first wash
- Machine wash warm or cold / mild detergent
- Dry on normal dryer setting
- Do not dry clean
Recommended Accessories
Heat Transfer Cover Sheet
TTD Masking Material (Carrier Sheet), this is not included with the pattern
Please Note: Due to increased heat and humidity during the summer months, we recommend allowing TTD Masks to return to indoor room temperature (below 70°F/21°C) before use for best performance. If additional cooling is needed, TTD Masks can be placed inside a fridge or freezer for 5- 10 minutes.